Gandalf the Grey - Lithophane

Custom lithophane stand included.

Software used:
Photoshop, Blender, Meshmixer, S3D.

Dimensions: 176mm x 164mm x 6mm (6.92 x 6.46 x 0.24 inches).

Print settings and information:
https://www.gadunky.com/litho-print-settings/

Note: This is a large and detailed stl file and may put some systems/slicers under pressure. It slices best in Slic3rPE, Cura 3.6+ or S3D.

A note on slicing in Simplify3D:
It’s easiest to slice the lithophane in Cura(or Slic3rPE) as there’s an extra step in Simplify3D due to the way the lithophanes are created(this by design to allow additional editing/printing options for more advanced users).

If you want to use Simplify3D you just need to do the following:

Load the lithophane STL into S3D as normal.
Click Mesh–Separate Connect Surfaces
Slice as normal
The added bonus of doing this is you can re-crop the image into the frame if you wish, or easily resize or remove the frame altogether.

If you don’t do the above in S3D there may be a tiny gap between the frame and the lithophane when you actually slice the model.

Check out more on my site: https://www.gadunky.com/

Print instructions

Print @ 0.1mm or 0.12mm layer height. 6 walls/shells and 100% infill.
Recommended material: Colorfabb Standard White PLA (it helps with the Blaze/hot look)

More info @ https://www.gadunky.com/litho-print-settings/