LipoGuard: TPU battery protector with slot for DroneKeeper Mini and 25° angle

This LiPo battery protector for bottom mounted batteries helps protect them while giving you a slot to store your DroneKeeper Mini. Also, it acts as a stand to take off at an angle of 25 degrees. The design is largely inspired by skullndrones's design and has influences from a design by 2mafpv (which is horrible to print, needs supports and is quite messy when printed with TPU due to stringing etc., not to mention it takes ages to print).

This version is faster to print and doesn't require supports. All overhanging sections can be printed as bridges and so if you control the flow and cooling right, you won't need any supports.Print with TPU for optimal results and to hold the DroneKeeper Mini snuggly.

The design weighs11.25g, when printed with the parameters as described below.

Print instructions

I printed this with a 0.4mm nozzle, an extrusion width of 0.5mm (all thicknesses are multiples of 0.5mm), 3 perimeters and no infill. 3 top layers are enough to fill in the small gaps even without any infill.