Long-range Antennas Removable Mount for Fatshark

Print the small part in rigid filament, and the big part in TPU for a nice fit of the sliding assembly mechanism (and for the SMA extension hex part).

The small part goes below the faceplate fan of the Fatshark Goggles, you have to remove the shroud with the 4 small screws and then place the "Base" between the fan and shroud.

15cm SMA extension is enough to reach the "far" antenna if it has an angled connector on the module side.

Prints without supports

EDIT: added version that puts the antennas at a 30 degrees angle to each other. Might be useful for traditional diversity receivers where both antennas work independently and you want to maximize coverage. If you request another angle please post a comment.