HeeWing T1 Ranger BN-880 GPS Tray

This is a tray that holds the BN-880 GPS and allows the wiring to drop down through either side.

I had seen a couple of other designs that required gluing into the fuselage, but my FC is mounted under the spot where this fits, so I needed it to be removable.

What I came up with is a tray that slots perfectly between the screws that hold the wing clips on, and sits on top of the incoming plugs. The rear hatch then holds the tray and GPS in place. This mounting position also stiffens the wings a little, since the fuselage can no longer flex inwards.

Once the rear hatch is removed this can be popped right out to access whatever is under it.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

Yes

Supports:

Filament: Hatchbox PETG