Elder Wand

Project file for the Elder Wand from Harry Potter

Printed vertically since I think the layerlines going around the model looks better than having it sliced along its length. I added support on the first layers manually, not for overhangs but for stability.

Vibrations

When printing the thinner part wobbles a bit when its half way done, so I reduced the print speed on the Prusa i3MK3S to 70%, later 60% to reduce the vibrations. I don't think it would tip over at 100% but the quality might suffer.

Layer Heigth

Since the Layers go “around” the model I don't think the 0.20 mm layer heigth looks bad. Sure, you can get improved detail with a lower heigth, but if you plan give it a layer of paint, most likely the paint will fill up the layer lines perfectly fine. The only place where you will see a difference is at the wide end and the engraved runes.

Other Wands

If you want other Wands, look up the models from the remix. Most models should work fine with these Settings.