Dual WaveShare 4.2“ desktop e-Paper case - symmetrical and without holes

Dual WaveShare 4.2“ desktop e-Paper case - symmetrical and without holes

Dual display version of my “WaveShare 4.2“ e-Paper case - symmetrical and without holes” display case as desktop variant. 

It can hold up to 2 ESP32 controllers and up to 2 LiPo batteries with 10000mAh and of course 2 WaveShare 4.2” e-Paper displays.

The inside is almost empty space so you will have lots of free space to keep the ESPs, displays and batteries. 

The outside is kept small with a footprint of: 120x100x45mm (WxHxD).

Note: If you already printed 1 display holder from this version “WaveShare 4.2“ e-Paper case - symmetrical and without holes”, you can reuse it for this variant and have to just print another display holder and the dual lid of course.

Printing instructions:

• I used the 0.2 speed profile and just turned the skirt off and 215°C for the nozzle
• For the 2 display holders an additional 5mm brim was set
• The 4 rings werde printed without a brim and with 100% infill
• The dial lid was printed without a brim
• The dual lid part needs supports from the print bed as the only part

Happy printing :)