Soap Holder (IKEA TISKEN)

No support - two part soap holder utilizing IKEA TISKEN for its base!

Only thing you need is a IKEA TISKEN (← click to open). Print both parts, insert first part onto the IKEA holder and slide the second part in. This is second part of my IKEA TISKEN series, so in case you are in a need of phone holder, go check it out here! :)

Printing details 

• Hook insert (Part 1): 
  • 0.2mm layer height
  • 3 walls/perimeters and 20% infill
• Soap Holder (Part 2): 
  • 0.2-0.28mm layer height
  • 3 walls/perimeters and 30% infill 
  • No supports*

*In my case, I was able to print this very well without supports using bridging only

Since I own only an ender 3 pro, I cannot tell if the tolerances are right for everyone so in case you decide to print my model, please let me know what printer you used and if it worked well for you, thanks!