Phone Holder, smooth tilt Australia REMIX

I printed this model but found the two bottom supports the phone actually rests on were too far apart for iPhones. So, I slightly modified these supports to better hold iPhones.

Please see additional print info. in the included PDF

Please post your make with the “Post A Make” button (below the “DOWNLOAD” button) on this page :D

Please hit the like ♥ and post your make with the “Post A Make” button (below the “DOWNLOAD” button) on this page :D

Follow me on
www.facebook.com/profile.php?id=100082036420297
Twitter: @Ozzy_The_Artist
 

Original Model details

Phone holder allows for fine control of tilt.  Probably overkill for most uses, but think this might be useful for video chat or work conferences where you want to get the camera angle just right.

Link to adjustment demo GIF:  https://drive.google.com/file/d/1McKVSAtGteZpH0tnaasFR7kEc2QWJiKA/view?usp=sharing

Print vertically on side with adjustment knob away from build plate.  Example printed with .2mm layer, 15% infill.  Recommend 6 mm brim ears with detection radius >10mm so gears don't get ears.

Had request for mod to accommodate smaller devices and horizontal position- version with full shelf will support smaller devices and horizontal phones - not tested yet.