Proteus Solder Station Accessories

These are contributions for a already well put together design!

I tweaked the articulated joints to be printed with TPU with a shore hardness of about 95A for the best holding power.

I also modeled a light fixture, in which I put a small strip of LEDs, soldered about 8 inches of two conductor cable, and filled with epoxy. The cable I ran through the holes on the joints to a buck converter. I would recommend the "Full Round Deflector" to be printed in TPU, the other can be printed with anything.

Finally, I remixed garMo's solder stand to attach to the left side. I'm sure if you want it on the right, you can just mirror it in Tinkercad.