Creality CR and Ender Filament Guide
Description
PDFI modified my other file due to the install of this EZR Struder on my Ender 3. My main motivation was to incorporate a place to connect my cable chain.That being said, there is an additional source file that I do wish I could give credit to, but there are now so many renditions, I wouldn't know where to start.
I have also added a retainer for some foam to wipe the filament.
CHECK YOUR CLEARANCE! This will reduce your maximum Z travel! I seldom do very tall prints, so I am not concerned, but fair warning...
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.24
Infill:
50
Filament: any PLA/ ABS/ PETG any
Notes:
I would run at least 50% infill. This is a part that you probably don't want to fail mid run, so make it strong!
Tags
Model origin
The author marked this model as their own original creation. Imported from Thingiverse.