This is a cable organizer and a shelf. It has lots of room for your cables and power adapters. You could also put it next to your bed to hold your cell phone while charging and it will hold your phone's charging cable when not in use to keep it off the ground.
It has two variations. One uses 3M Command Strips and the other uses Screws.
Print Settings:
4 Walls
5 Top
5 Bottom
15 % infill
Printer:
Snapmaker 2
Rafts:
No
Supports:
No
Resolution:
0.16
Infill:
15%
Filament:
Snapmaker PLABlack
Notes:
This should print fairly well as long as you can get the first layer to stick.
The author marked this model as their own original creation. Imported from Thingiverse.