Pickle Rick Soap Dish

I printed the base as a vase mode print, on a 0.4mm nozzle using a line width of 1mm. Vase mode is not technically necessary but I wanted to avoid a seam.

Additional note on the base & vase mode is that I noticed quite a difference between vase mode sliced in Cura 4.11.0 & Cura 5. 

Cura 5 would not slice the base correctly in vase mode, even when I handed it a solid model, it would not correct spiralize the outer contour of the model.

The insert & the faceplate are both oriented correctly for printing. Both recommended to be printed at 0.2mm.

I printed the faceplate (pickle rick) at 0.2mm, face down for smoothness on glass & inserted a color change on layer 3.