Adapter from 1/4" male to M14 male for a plasma cutter

A simple adapter I made to connect my plasma cutting torch to an air compressor. Use Teflon tape on the 1/4" end to screw in the rest of the armature, the hemispherical end was well sealed without any gaskets with a PET-print.

Print Settings

Printer:

Craftbot

Rafts:

No

Supports:

No

Resolution:

0.1 mm

Infill:

25 %

Notes:

Use thick walls and 10 top/bottom layers. Print slowly for precision, I used 20 mm/s. I would suggest you use PET, it is a good material for this kind of thing, because it is not brittle, but Nylon, PC, ABS or PLA (listen in order of suitability, PLA can be brittle) should work too.