Badge holder

A simple badge holder with 20 hooks. It has a roof preventing the gathering of dust on the badges. The hooks are curved back to keep the badges fixed.

Print Settings

Printer:

Heavily modded Craftbot

Rafts:

No

Supports:

Yes

Resolution:

0.3mm

Infill:

15%

Notes:

Print turned on the side to keep the supports to the minimum - this way they are minimal, only needed under the hooks. Use any resolution you like, but this is a big print, so it will take a while. Do not print faster than about 50 mm/s or the rather thin print will move and the surface will be rough.

Clean up the print and glue it to the wall using either Tesa strips for posters (removable) or some silicone.