Cable clip for mounting with a staple gun

An extremely simple clip designed to be fixed with a staple gun. I find it much faster and easier to work with than the standard cable clips with a nail. Picture shows a quick and dirty install I did with these.

Print Settings

Supports:

No

Resolution: 

Any

Notes:

Model should already be oriented correctly, simply multiply as needed. Just over 0.4 grams of filament per clip without scaling.
Use a tough material that will not shatter when stapling it: I used ABS. HIPS and nylon should be best, ASA and similar materials should work too. PLA and PTEG probably will not, because they tend to shatter.

The clip inner diameter is 5 mm and just right for network cables. If you have a thicker or thinner cable, simply scale the X and Y as needed.