Filament Guide Wall Mounted

Created specifically for my 3D printer enclosure to guide the filament to be better inline with the extruder.

Printed in PETG to resist the heat a bit better.

The screw and cap fit together but are quiet tight the first few tries, this will loosen up after a while. There is about 0.2 mm clearance between the screw and holes. Clearence between the wall mount and the roller is 1mm on each side.

Print settings:
Hotend temp = 230 *C
Bed temp = 90 *C
Layer height = 0.2 mm
Support = No

Print speed = 50 mm/s
Outer wall speed = 25 mm/s

Note:
Support might be needed for the wall_mount and/or roller depending on your printer.