Giraffe fridge magnet - Žirafa magnetka na ledničku

I created a fridge magnet for my two-year-old daughter.

Due to the variety of magnets, add the place on the magnet yourself as a negative volume. Insert it into the body about 0.5 mm above the first layer so that the child does not accidentally get on it. 

Or just edit my nedative volume in 3mf file to fit your magnet.

In slicer add pause before hole for magnet is covered by next layer. You can see it in my file after you slice it.

I use roud (cylinder) neodymium magnet 10x2mm. For better insert i made negativ volume 10,1x2,1 mm

Use ironing on all top layers.

In past i allready upload cat fridge maget. I dont want to reupload it for contest so just check in link below. if you want.

https://www.printables.com/cs/model/158556-kitty-fridge-magnet