Electronics junction, switch or utility box 110x190x150

I needed an electronics box to house my rather long 3-fase 4-way switch to switch my heavy equipment behind a rpm controller.

This box is 190mm wide, 110mm high, and 150mm deep. (can fit equipment less then ~140mm long).

The hole are easy to drill to size with a step drill bit. I made made center points so you can easy drill in the center.

I also added 2 screw holes in the horizontal direction to fit a DIN rail.

Disclaimer : This file and/or any information around it is shared as is and can be used at your own risk. As it is related to electronics the user should understand and be aware of potential hazards and know what he or she is doing.

Print instructions

Category: Electronics Print Settings

Notes:

Printed base in PET 0.2mm

Printed lid in PLA 0.2mm with face side on the bed and with support from bed to support the screw holes and corners.