Magnetic Tissue Box Wall Hanger Remix (Dual size box capable)

I redesigned the remix I made to Xuis's design (https://www.thingiverse.com/thing:4362143). Now it not only is capable of holding various size and shapes of tissue boxes (original remix I did), but now it includes 4 pockets for neodybium bar magnets (60x10x3mm) that you can get on Amazon for about $1/magnet depending on how many you purchase at once. Other than the magnets, it's the same design as my original remix, so it can also just be mounted to a wall with screws or tape.

Do NOT use supports, or you'll fill up the lower two magnetic slots and never be able to get the support material out. The upper end of the lower two magnet slots have fillets to ensure no support is needed.

Use a brim to ensure the corners don't lift up during the long print.

Print Settings

Rafts:

No

Supports: 

No

Resolution:

0.2mm layers (0.4mm nozzle)

Infill: 

None if you set wall count to 8+

Filament: Any PLA or PLA+ Any

Notes:

NO SUPPORT or you'll be struggling to get the support out of the lower magnet pockets.

Print with a brim to ensure the corners don't lift up during the print due to uneven cooling.

Category: Organization