Truma roof cap camper

This is a truma roof cap. I printed from ABS, but I think PETG is good to. The first is fits but a little bit it was a little bit loose, bit it can be tighten. (it's in its plase about a month without a any problem)

I uploaded the thread lib too.

This version is not yet printed by me. I increased the thread from 59.5 to 59.7mm.

2017-04-18:

I increased the thread size to 60 (from 59.7). I printed only the thread to test it. It fits good for the original hole.

I also added stl file.

2018-09-13:

Okay, printed and tested the whole thing. The thread is good now.

Print Settings

Printer:

prusa i3 rework 1.5

Rafts:

No

Supports:

Yes

Resolution:

0.3

Infill:

30%

Notes:

I printed from ABS, but I think PETG is good to.
Printed with support, and later removed it.