Everyone loves 3d designs with press-fitted neodymium magnets but no one likes pressing them in. Magnetool is specifically designed to ease this process and give you total control over the polarity of your magnets.
You will never have to worry about putting a magnet int he wrong direction again!
Magnetool includes press-fit holes with engraved marks that allow you to put magnets with opposing polarities at each ends.
Once these magnets are put in the tool is ready to work! Simply used the magnetic ends to position the magnets over their cavity, then slide over to a corner and start pushing!
Magnetool's design allows for maximum force, no matter your grip
To build Magnetool you will need 2 neodymium magnets.
The initial version is built to work with 5mm wide, 0.9mm thick magnets
Prints best in the slicer screenshit (standing up) to ensure the magnet cavities have exact sizes
I was able to print it in this orientation without support on my prusa mini but one side looks a bit ugly
The author hasn't provided the model origin yet.