Voron 0.1 toolhead on Prusa Mini+

I created this mod because I was not too fond of the part cooling on the original Mini because I was pushing speeds using Klipper. I also had issues with the original hotend's capabilities.

This is a quick remix of multiple different models to fit the Mini After LGX Lite Upgrade Kit for Voron V0 fromBondtech using a remix between the linear bearing mount from Sebastian's Dragon hotend mount.

I also remixed the “Cowlin" from the Bondtech Upgrade kit with the MiniAB Pinda mod to get the probe on the “Cowlin". 
Link for the MiniAB Pinda mod: https://github.com/VoronDesign/VoronUsers/tree/master/printer_mods/MrDespair/MiniAB_Pinda

The mount on the linear bearings isn't super rigid since I just designed everything in a hurry.

This mod will reduce the printing volume by x:10mm and y: 5mm because of the difference in nozzle placement + the “Cowlin"".

Link to Bondtech's article about the Upgrade kit:
https://www.bondtech.se/2021/12/27/voron-v0-1-toolhead-setup-for-lgx-lite/

I printed my parts in ColorFabb's HT material for strength and temperature resistance and I would recommend something similar.

Note: I'm not the best at 3d modeling but it works and any feedback would be highly appreciated.

I've also only tested this with the Dragon hotend. but other hotends that fit the kit should work no problem

The original part cooling shroud DOES NOT WORK with this mod. I haven't gotten around to create a model for it. I just cut half of it off