spitvalve (waterkey) replacement for Allora Aere plastic trombone

Replace your broken spitvalve (waterkey) on the Allora Aere plastic trombone.

Print Settings

Printer:

Sovol SV01

Rafts: 

No

Supports:

No

Resolution: 

0.1 mm

Infill:

100%

Filament:

CC3D PETG

Red

Notes:

Installation instructions:

• Install the lever on the trombones slider by pressing it against the spring and lining up the axle hole. 
• Slide in the axle. 
• Lift the lever while holding the slider with the drainage hole pointing downwards. 
• Put a small dollop of cyanoacrylate superglue on the corresponding surface on the lever. 
• Turn the slider upside down while holding the lever lifted.
• Place the half sphere stopper on the seal of the drainage hole.
• Place a small dollop of polyurethane gorilla glue on the flat surface of the stopper. 
• Release the lever allowing the spring to squeeze it against the stopper. 
• Wait a couple of hours for the bond to form between the two parts.

Category: Music