Dishwasher Signage - Clean or Dirty

Is it clean? Is it dirty? 

Use this to denote the state of the dishes without having to open up the dishwasher and look inside. If you have a textured round dishwasher handle that is 25.52mm in diameter, you'll have no issues with this.
 

Instructions

• Can be printed on Prusa Mini+
• Before you invest time in printing this, make sure that your printer can do the proper clearance. I added a TestFittingForLegs.stl file. 
  • Print 1 of those, and 1 legs. If everything works, then print everything else! 
• Use whatever infill you'd like. I chose 10-15%.
• On the signage plates, print them letter side to the plate. You want a nice smooth side against the plate.
• On the actual lettering, print those nice side down. You want smooth/textured/satin texturing on the letters, unless you prefer ironing. I'm not the boss of you, do what you want.
• There's only 1 leg model. You want to print 4 of them.
• Magnet holes are 6mm (width) by 3mm (height)
• I used 3d Gloop to hold the lettering into the recessed letters, I'm sure superglue works just as well.

Version Notes:

• Version 2 features are:
  • Squatter legs, bringing the signage closer to the dishwasher handle, and using less filament.
  • Thinner signage, (from 4.5 mm down to 2.5 mm ) using less filament.
  • Rounded corners
  • The area that the legs lock into have been beefed up a little to withstand floor impact. After a drop to the floor due to rough handling, a triangle area cracked.
  • Looks like the dirty hole issue has been resolved.
  • Unless I bump into an issue, this will be the last version.
• Leaving the files of version 1 up as an archive just in case someone needs the original.

I'm learning Fusion 360 still

---
You may not sell my print. 
You may not sell my files.
Feel free to remix for your own dishwasher.