Training Poi

This is the design for some poi. Useful for beginners to train with or to give as a gift.

Obviously these should not be lit on fire. But the loops can be used to attach ribbons or yarn.

Assembly Instructions

1. Tie a knot on one end of the rope.
2. Thread the rope through both the top print and then through the grip.
3. Tie a second knot and cut the rope to the desired length.
   • Note that the length will increase slightly as the knots tighten during use.
4. Attach the bottom print to the top print and bolt togethor.

Non printable parts required:

• 8mm Cord/Rope (preferrably not nylon)
• 6x M6 Nuts
• 6x M6 Screws

Print Details

• Nozzle: 0.4mnm
• Layer height: 0.2mm 
• Material: PLA
• Printer: Ender 3v2
• Support Required