Square inner flower pot with stand

Description of the pot

I needed a little inner flower pot for a square shaped planter. I made a very simple design with the side length of 56 mm on the top and 46 mm on the bottom with the height of 50 mm. 

There are holes on the bottom and to make them effective for allowing to let the excess of water through a small stand can be glued on the bottom of the pot - however gluing is not necessary if the inner pot fits to the outside one tightly enough.

Printing

It is possible to print the pot quickly as a spiral vase if the wall is printed thick enough (around 0,75 mm should be sufficient). The model can be scaled to the desired size. I printed these pots in PLA with hotend temperature of 230°C to assure good layer adhesion and water tightness.

Conclusion

If you would have any suggestions to this design, please, let me know – I will be happy to upgrade it.