Phone/Tablet Stand- Phones & Tablets with cases!

There are a MESS of tablet stand designs out there, but none seem to fit tablets with the cases on them, only seem to be designed for bare tablets. I like my highly protective case, so I designed this simple stand to hold my tablet so I can watch things like instructional videos on it while working on the computer.

Fits the thicker, more protective cases that are 2 or 3 layers of protective material.

Print light if you wish, I printed one with higher 1st/last layers and more shells, also printed this one with just 1 layer starting and 2 top and 2 shells with 15% infill. and it's higher and works just fine. I wouldn't go less than 15% infill as the front 2 tabs may end up too weak at that point depending on your slicer ad infill layout.

Print instructions

Category: Tablet