UPDATE2
By request, added a version of the 4x4 16mm one with a handle.
UPDATE
Added a version with 6 holes and a handle for moving the bed. Putting the spacers around the edges is easy once the frst six screws are in.
If you take the heated bed off the CR-10 Smart it's a real pain to put back on as there are 16 holes with plastic spacers under each one and it's almost impossible to stand them all up on the y-axis frame and put the bed on top without knocking some of them over. The four in the middle are the worst.
These four files should help - fix one of them to the y-axis frame with the holes lined up with the holes in the frame. There is a 2x2 version and a 4x4 version, stick them to the frame with something and you should be able to stand the spacers up in the holes and then carefully place the heated bed back on top before re-inserting the screws.
There are two versions of each, one for the original 9mm diameter spacers and one for 16mm silicone spacers (which are preferred)
I printed them as they are on the Smart with no supports and a skirt, 10% infill in PLA+ but any material should do
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
No
Resolution:
200
Infill:
10
Filament: eSun PLA+ Red
Category: 3D Printer AccessoriesThe author marked this model as their own original creation. Imported from Thingiverse.