Bed Wire Management (automotive loom) Version 2.5

minor update and a few modifications to my bed wire management clamp(works best with 3/8" automotive wire loom) Mostly just added an angle upward slightly for more even flex and made the mount wrap around the loom instead of inside to give wires more room.

•NOTE-. there is no mounting hole, there are just too many different beds, carriages and such to have them all. Simple though, just take the screw/bolt that will fit your printer, heat it lightly with a lighter and stick it through. the plastic will melt easily and this allows you to position it best for your model/design of printer. •

Print instructions

Unassociated tags: automotive loom, heat bed
Category: 3D Printer Parts