I had major problems with filament jumping from the roll when the roll was full. So i designed the guide which centers the filament on the roll. Since the guide is installed the problem wieht the jumping filament is a thing of the past. :)
The filament holder can be found here. https://www.thingiverse.com/thing:2700583
Printer:
anycubic kossel
Rafts:
No
Supports:
No
Resolution:
0.3mm
Infill:
15%
Category: 3D Printer PartsThe author marked this model as their own original creation. Imported from Thingiverse.