Fan with Wire Management - Max Micron and other Prusa i3

Just added wire management to my improved parts cooling fan shroud.
Version without wire management if you prefer... http://www.thingiverse.com/thing:1794658
• Improved cooling over stock unit as the fan duct is brought in closer to the needed area but much less general air blowing around the nozzle and heat block.
• Better view of the nozzle with the duct tucked up closer to the carriage.
• small shield in mouth of duct to lower direct air flow at the nozzle tip.
• better access incase of failure or other issues than many of the modified shrouds that wrap around and block the nozzle
• Added simple wire management coming off the head to avoid droop and lower wire stress during movement.

Note- check your layers in the slicer, rotate the model on the bed to get the support material to run front to back over side to side as it's a LOT easier to remove from inside that way.

Print instructions

Unassociated tags: Max Micron, Wie managment
Category: 3D Printer Parts