Fridge shelf for Frigidaire 241691311

This is a replacement shelf for a Frigidaire 241691311 refrigerator. It goes on the upper section of the door. The shelves that come with this refrigerator are an extremely poor design, and break almost immediately if you put any weight on them.

You have to print this is two halves (just mirror the model in your slicer for the other half). I pegged the two halves together with 3mm ABS filament dipped in acetone (the yellow line in the picture is due to the yellow ABS I used). Printed in PETG with .4 mm layer height, 50% infill. You could probably go lower on the infill, but I wanted to be sure it would hold up better than the original.

Edit: I added a dimensions sheet to the files so it's easier to tell whether it will work for you. Also, I printed another one of these in PLA, and that worked fine too!