Hey guys, I'm a bit confused about this mod and was wondering if anybody could help.
As you can see in this image, my extruder faces the far end of the X axis, but this mod requires that it faces Y axis.
Am I using a different type of extruder? Or has everybody else rotated their hotends?
Would greatly appreciate any help!
can anyone share cad files pls, i need to adapt it for bmg extruder and 3010 fan
This would fit a KP3S Pro S1 I assume, but can someone suggest me a V6 hotend from aliexpress that works with this? Want to upgrade to all-metal so I can print at hotter temps, and thinking of replacing the entire hotend instead of just the heatbreak.
remixed it a bit to fit 4020, but it came out with fitting problems, maybe someone will do a better job. Original model is great, but hard to mount 5015 turbine without gaps
Love the design! Klipper's input shaper claims it can reach 4600 mm/s² without smoothing, unfortunately can't use its potential because of the bed (2800 mm/s²), so #justbedslingerthings.
I'm thinking about making a little thicker remix with M3 heat inserts, because two nuts did fall off once and tightening them too much resulted with damaged nut sockets, so I needed to reprint the fan duct part.
Anyway, a great design! Thanks!
(Rosa3D PET-G Standard) (edited)
@mtczekajlo_610876 I've not finished tuning my kp3s yet just using the kingroon profile from there blog but printing faster than that with a textured pei bed and stealthchop disabled. Considering disabling stealthchop, involves soldering a single point on the mobo and removing some resistors, easiest with a 858d hot air station and smd 0ohm resistors.
https://www.youtube.com/watch?v=BF19ZXk5KRw
