FGC-68 MKII tipx edition: T15 UAL (UPPER and Lower) set

11-10-2024
M5 nut lower have been added. for a stronger connection

it will use a 30mm long M5 bolt with 3d printed grips
-------

FGC68 GEN2 Updarted 

the link to the new manuals and parts list can be found here https://drive.google.com/drive/folders/1POafTye0p9ps3qhr2-nWT2uAPL3kko1u?usp=sharing

____________________________

I have updated to a V2022 version this version should take out the barrel wobble. 

----

this is the UAL version of the T15 “lower” so this means more parts to reprint in case you already have the standard FGC68TE.
but this does make it a direct feed with your T15 V2 mags so you can use them to shoot first strike rounds. if you have TCR or a TiPX long range kit or something in that nature…

it’s also possible to use the V1 magazines but the 2 screws on the top of the mag are in the way. so if you don’t mind making a small mod to your breach block then it should work fine

in case you have just a regular TIPX breach block for round ball use then you can still use this set. just keep in mind that you can’t use first strike rounds in that case.

the starter set can be found here:
https://www.printables.com/model/87803-fgc-68-base-package-starter-set-for-tipx-tcr-magfe

the collection of FGC68 parts can be found here:
FGC68 MKII
https://www.printables.com/social/180009-untangleworks/collections/88908

FGC68 MKI (this set is not made for the MKI version)
https://www.printables.com/social/180009-untangleworks/collections/88907

a video about this lower will be made later:

some of the installation steps that are different from the TIPX lower can be fund in the images for now

parts needed for mag catch.
1x spring 6mm OD, 0.5mm wire, 20mm long
1x m3 bolt in a length of 30mm
1x m3 washer
1x metal pin 4mm OD, 27mm long (a 3d printed part can be used for this)