Accessories for Shaper Workstation MFT

I3 MK3S

Yes

50

Choose any colour you like. Bench Dogs should have at least 50% infill. All other part can have less and must also not be PETG.

Accessories for the extented Shaper Workstation. A MFT like base with 48mm spacing and 20mm holes. So many of the other MFT tools should work here too.
My main purpose was to do cuts with the Shaper Origin without harming the MFT surface.

To do so, the work piece rests on bench dogs with small rubber pads. Also a fixation with special stick pads (that fit around the bench dogs) and double sided tape is possible. To have a support for the Shaper Origin with small work pieces there is a height adjustable support bar. It consists of three parts the base for the bench hole, the extention and the adjust knob for the top (included STL files work for 19mm thickness).

The original Shaper Workstation support bar could the uses with extention to allign the work piece against it in the middle of the MFT (at the end of the support arms).

All parts could be modified in Fusion360.

Infill: Bench Dogs 50% all other part 10-20%

Filament: PETG for Bench Dogs. Other parts PLA should work.