Ender 5 Enclosure

This is the enclosure I designed for my Ender 5. The design took inspiration from the Prusa Ikea Lack enclosure.

The height of the enclosure is adjustable to your liking. It's based around 25x25mm aluminum extrusions. Mine were 1m in length and I kept them that way. If you use a shorter length you can probably do without the mid supports.

Apart from all the printed files here's what you need:

-Ikea Lack 200.114.08 [2x]

I dont use the legs of the second table so you can put something else on top if you wish.

For the hinge:

• M6x70 Bolt [2x]
• M6x60 Bolt [1x]
• M6 Nut [3x]

For the door:

• M4x12 Bolt [10x]
• M4 Nut [10x]
• Neodymium magnet 5x2mm [16x]

For the corner pieces:

• M3x12 Countersink screw [16x]
• M3x30 Countersink screw [24x]

If you change the height of the enclosure change these to fit.

• 1m 25x25mm aluminium extrusion [4x]
• 1004x488x2mm Plexiglass [3x]
• 997x482x2mm Plexiglass [1x]
• Foam strip [15m]

Because you need to extend all the cables to connect the printer you also need:

• JST SM connectors male/female (you only need the 2 pin variant but it doesnt hurt to pickup a complete set)
• Some wires (i used 22 AWG for everything that's not heating anything)
• XT-60 connector male/female for the heated bed
• 12 AWG wire for the heated bed

The hot end cartridge was long enough to fit without any extensions