Phone Stand for phone with popcap / battery case
Description
PDFSimple phone stand designed in FreeCAD to accommodate phones with popcaps and / or battery cases. Designed with iPhone 7/8/SE in mind in a slim battery case, both with and without a popcap. Should fitmost phones. Your mileage may vary.
Tested in portrait and landscape - popcaps were more or less centered. Also used with 10.5-inch iPad Pro (in portrait only). IF using with iPad, be careful not to topple.
Phones may slide around a bit because the "hook" is large to accommodate phone+battery case.
Channel on underside of feet is for glue-stick glue - for grip / non-slide.
Print Settings
Printer:
FLSUN QQ-s
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
10%
Filament:
Hatchbox PLAWhite
Notes:
I used Cura 4.7.1 using "Tree" supports with a skirt. Extruder at 205 and bed at 65 running at 100 mm/s on the FLSUN QQ-s.
This is the 6th iteration to accommodate placement of popcaps and provide for a relatively short print time. I print these in just under an hour.Post-Printing
For non-slip feature, use hot glue
All I did was squirt a bead of hot glue into the channel and then use a knife blade to press flat and shmoosh the hot glue into the channel. The channel is supposed to keep the hot glue from peeling off - YMMV.
Tags
Model origin
The author marked this model as their own original creation. Imported from Thingiverse.