Coffee Drip Tray Spacer/ Riser

I have a Keurig for tall cups but the space between nozzle and the cup was so far that I would get splashing on my counter. I created this to raise the cup up to the height of the nozzle. This is exposed to heat so make sure you use a filament designed for high heat.

As long as your coffee maker has a hole in the center of the drip tray this should work fine for any brand.

This is my first original design. I had trouble getting the pin to print but after I adjusted the infill pattern and density it printed fine.

The measurements are

Disk Height 15mm

Disk Diameter 100mm

Total Height with pin 20mm

Diameter of pin 20mm

Diameter of pin recess 21mm

I am in the process of designing a tray for them to nest in because they keep sliding around the counter when not in use.

EDIT----------------------------------------------------------------------------------------------------------

I have not yet printed the holder or feet. The feet should be printed in TPU and be able to be inserted into voids in the bottom of the holder. You can use any filament for the holder because it will not be exposed to heat.

I also added a rounder version to the spacers.

I will post updated pictures when i have completed the printing.

Print Settings

Printer Brand:

Bambu

Printer: 

Bambu X1 Carbon

Rafts:

No

Supports: 

Yes

Resolution:

Does not matter

Infill: 

20% Lines in Cura

Filament: Heat Resistant

Category: Kitchen & Dining