Ultimaker 2 Aluminum Extrusion 3D printer - Sides Bottom Bracket with rear I/O Panel

This is just a quick design I made for the rear I/O of the printer. It replaces one of the bottom corner brackets and can fit a power connector, USB pass, ON/OFF switch (17.5x12mm cutout) and a fuse holder (panel mount fuse holder for 20x5 mm fuses, hole-diameter 12mm).

Update

I put the mounting holes for the USB pass on the right side (when looking from the back of the printer) because it was interfering with the z axis stepper.

Print instructions

Category: 3D Printer Parts Print Settings

Printer: Vulcanus V1 MGN12 upgrade

Rafts: Doesn't Matter

Supports: No

Resolution: 0.2mm

Infill: 10%