Pinecone Lampshade

These files are for Personal Use Only. If you would like a Commercial License to sell prints made from these designs, please join me on Patreon: https://www.patreon.com/kazitoad

This stylish lampshade is perfectly illuminated by a standard lightbulb and designed to be printed in spiral vase mode. 

The lampshade is ~180x180x190mm, so it will fit on most 3d printers. I have included two mounting plates, one is designed with a 10mm slot to accommodate the light fixture I have on hand, the other mounting plate is blank so you can modify it to fit your needs. 

The lampshade should be printed in spiral vase mode with the narrow side down. It should be printed with a single wall 1mm wide (or as wide as you can go), and with at least 2mm of bottom layers (~6 depending on your layer height). 

All parts should be printed without support.