Printed a slimmer version by scaling down on the side. Loving this design and my go to print for last pieces of filament.
Ikea BROR Hook
Simple hook for headphones, cables, etc. Compatible with IKEA BROR storage shelves.
26
171
5
962
updated May 22, 2024
Makes
Comments
Printed in PETG, I didn't use any double sided tape because I like the possibility of moving them around as needed. Ingenious design, thank you for sharing!
What a smart design. Good job! The print is easy and I had no issues installing it. Also I don't find it to be weak, atm my quite heavy backpack is hanging there.
Same here, printed 2 with PLA and both broke while inserting :(
@Maciej_207009 Please check my response to @AndKle_513234
I tried to print two of the hooks with PETG. Both of them cracked, while inserting. :-(
Which print settings did you use?
@AndKle_513234 Oh, I am sorry to hear that, I have printed both in PLA and PETG with no issues. I used the settings recommended by the filament manufacturer. Make sure it is printed in the correct orientation, the 3D preview shows it in position it should be printed in. Installing it should not take any force at all, it should just lever into place under its own weight.