coffee printable

coffee printable

small coffee table, made of ply wood 22mm thick.

original design, over all dimensions are 80cm x 60cm x 45cm.

table top dimensions are 80cm x 60cm 

legs are a combination of two parts per leg 43cmx 10cm with a taper that ends at 5cm, and 43cm x 8cm with a taper that ends at 3cm

3D printed parts took 10hours each (one part per leg) on my anycubic i3 mega for a total of 40 hours at 20% infill no supports needed.

assembly is very straight forward, slide the legs into the part, i recomend sanding the legs because its a very tight fit, or increasing the part by 1%. a couple of screws in the screw holes and you are good to go, make sure you use longer screw to join the legs together. 

total build time without print time is about 1-2 hours if you have the right tools

tools used and recomended are: circular track saw, drill, sander, hammer and straight edge

plus some screws