Balloon Boat

This is a boat, that can swim over the water by help of a balloon!

1. Put a balloon over the chimney and blow in the exhaust.
2. Set the boat on top of water and release the "air hole".
3. Have fun!

Print instructions

Category: Toys & Games Print Settings

Printer Brand: FlashForge

Printer: Creator Pro

Rafts: No

Supports: No

Resolution: 0,2

Infill: 15%

Notes:

Support is only needed under the exhaust in Version 1 (Boot9-4). DO NOT USE "AUTO-SUPPORT", CAUSE IT WILL CLOG YOUR CHIMNEY!!!!

The second Version can be printed without any support, but i don't know, if it will swim...
Test it and tell me ;)

*Edit: Version 2 (BootV2-2) works just fine. Look at the pictures... and... it swims, too! ;)