TBS Source One XT60 + SMA Mount

This model is inspired by this entry, but modified to fit the 5-Inch version of the TBS Source One frame. It is also a bit easier to print, because I reduced the angle of overhangs.

There are different versions of this mount for the 5-Inch and the 3-Inch version of the TBS Source One frame. Please make sure to print the correct size for your quadcopter!

The 3MF-files include PrusaSlicer printing settings for TPU filament.

There are also STEP-files to make remixing easier. The simplified STEP files can be more easily edited than the final versions, which include a lot of fillets.

Side Note: If you're interested in the ELRS antenna holder that's shown on the pictures, check out this design.

Category: R/C Vehicles