Spiral Speaker Table

I designed this for a friend, who needed to raise his speakers up to ear level for a better listening experience. 

The table is approximately 150mm high, and sits on a desk

The Pillar Centers are printed in two colors, I printed the disk part in black then paused the print and printed the rest of the pillar in purple. 

Printing the Spiral Pillars  worked best with low layer height.

Assembly 

This Table will need to be glued together. I used a Super Strength Epoxy adhesive with a slow curing time.

First you need to glue the Pillar Spiral to each Pillar Center. 

The Pillar Centers are printed upside down, the disk part of the Pillar Center sits on the spiral ends. Epoxy around the Pillar Spiral hole at the base and dab a little epoxy to each spiral end, then drop the Pillar Center down onto the Pillar Spiral. 

Once the Pillar Center and Pillar Spiral are fully bonded they can be glued to the Table Top.