Underslung X Endstop for extreme X travel (MakerFarm i3v)

This is a new X endstop mount for MakerFarm i3v printers to extend X travel further to the right. This allows the left extruder nozzle on dual extruder setups to reach more of the bed.

On the 12" i3v with the Itty Bitty Double Flex extruder, the left nozzle should be able to reach the edge of the glass, so you can use the entire bed for single-material prints.

The mount installs under the lower X extrusion with an M5 screw and T-nut and provides an opening to route the wires behind the Z screw.

Instructions

• Install the endstop mount under the X extrusion with an M5 screw and T-nut.
• Mount the switch with two M2.5x12 screws.
• Route the switch wires through the opening to keep them in place behind the Z screw.