Noctua60 holder for Anycubic Predator

Another holder for replacing the Predator stock board-fan.

The stock fan is damn noisy, and mounted to the baseplate it's amplified even more.

This holder is done in soft TPU and will dampen the resonanse in the baseplate.

The fan just click into the two small notches, and you can use the silicone pegs that comes with the Noctua to secure it. But it will sit just fine without.

It has two Ø10x3mm neobdynium magnets to hold it firmly in place.

The stock fan is 24V, and this 60mm Noctua runs on 12V, so you need to add a step-down module as well. I found this tiny board for this, and mounted it on top of the fan with a piece of double-tape.

Remember to adjust the step-down module to 12V output before you hook up the fan.

https://www.ebay.com/itm/MP1584EN-Ultra-Small-DC-DC-3A-Power-Step-Down-Adjustable-Module-Buck-Converter/122054336107?hash=item1c6b015e6b:g:GTwAAOSw0fhXkFD8

Print Settings

Printer:

Anycubic Predator

Resolution:

Infill:

20%

Filament:

Blue