Anycubic Vyper Palette2 Filament sensor PTFE Guide

Needed a solution to have a proper guide for my Palette 2s PTFE tube. The bracket that came with the palette wouldn't work with how the filament sensor is mounted on the Vyper.

The rubber grommet that comes with the Palette will fit perfectly in the hole closer to the filament sensor. Also has a strain relief for the tube

When not using the Palette, the bracket works fine for bare filament.

You will need to clip off the filament sensor bracket and mount the sensor to this bracket.

Parts needed:

2x M3x25 Screws, Nuts, and Washers

Print Settings

Printer Brand:

Anycubic

Printer: 

Vyper

Rafts:

No

Supports: 

No

Resolution:

.2mm

Infill: 

10%

Filament: generic PLA blue

Notes:

I usually go with at least 4 perimeter walls for anything mechanical. (0.4mm nozzle)

More perimeters is stronger than increasing infill most of the time

Remixed from https://www.thingiverse.com/thing:4910253

Category: 3D Printer Accessories