Prusa Einsy Case for enclosure with active cooling

I used KalleKnall's design to modify it to include active cooling. I removed the area of the Raspberry because I have my Raspberry outside the print enclosure. I use 2 fans, the upper one blows the air onto the Einsy board and the lower one draws the air from the Einsy board outside the enclosure.
The fan cover comes from the inside in front of the cover and thus prevents the cable from getting into the fan. At the same time they are used to screw the fans on.
It is best to mount everything on the cover first, fan, duct, etc. and then close the cover.

Print instructions

All parts can print without support.