Williams Strike Master Bowling Pin

This is a replacement pin for Williams strike master. It should fit any other bowler that uses a 10 1/4" pin. I found these were slightly heavier than the originals, so I shortened the up spring by 3-4 loops and it works perfectly.

I used this file as a base to design, but thingiverse isn't allowing me to add a remix right now.

https://www.thingiverse.com/thing:15859

You will need a tall printer to print these as it's taller than 250mm. The game is currently on location and the pins are holding up really well.

Print Settings

Printer:

Custome Tronxy x3a

Rafts:

No

Supports:

No

Resolution:

0.4mm

Infill:

10

Filament:

Gold Silk

Notes:

I use a wide brim to stabilize.